Posted: 8/19/2017 9:02:21 PM EDT
|
Finally got to shoot my RMRed 19. The first few shots were fine, then I noticed the RMR kind of flashed during the shots, and now it is like a big blur. What would cause this? I changed batteries, and it it still the same.
Thanks ETA: Its not my eyes, because my Burris FF3 looks fine, and the RMR looked fine until I ran rounds through it |
| Battery contacts probably. Not sure if your using sealing plate but it helps. I use sealing plate wrapped in kapton tape and it works for the three i own. I will admit my first one had to get sent to trijicon and since it's back it's worked flawless after like 3k rounds. There's a company that sells a sealing plate that pushes the battery further up into optic to make better contact. |
|
Quoted:
Piece of electrical tape on the bottom of the battery And bend the side battery contact. (Good info on this in the Roland Special thread) https://www.AR15.Com/media/mediaFiles/108584/20170711-103026-251389.jpg |
|
Quoted:
I don't think he's experiencing the flicker issue some of us have seen... it sounds like an emitter issue that Trijicon will need to remedy for him. |