Posted: 7/8/2015 12:28:16 PM EDT
|
So...on a recommendation I bought a Ghost 3.5 Ultimate trigger. Any reputable videos for proper installation and what are everyone's feelings on these? |
| I have the ultimate connector and 6# trigger spring i love it. No mush and clean crisp break with short take up, it takes about 10 seconds to install don't remove all the pins just the rear pin if you're just installing the connector. There is plenty of vids on youtube |
|
Just about any video should do being drop in. Ghost has instructions, if you didn't see them. It's very easy.
Can't speak to the Ultimate, I got the Pro. |
|
I like them. Got a Evo Elite in a G19G4 and it is really nice. Do you have an armorer's slide plate? This is essentially a slide plate shortened to see the striker and cruciform mating. During fitting of the Ghost connector, in order to get the best over-travel you have to reassemble the pistol several times. The armorer's plate lets you release the striker when not enough material has been removed from the connector. |
|
Quoted:
Just about any video should do being drop in. Ghost has instructions, if you didn't see them. It's very easy. Can't speak to the Ultimate, I got the Pro. I have a Pro as well and also just looked at Ghost's instructions before installing. Pretty easy install; I used the face of a dremel cutoff wheel to grind down the TCT. |
|
Well I installed it (Which was very easy) and retracting the slide was kinda....hesitant or sluggish is the word im looking for I guess. Ran two mags thru her and its much better. Reset is more positive and trigger breaks cleaner. Cant feel a weight difference but that's because I didn't change the spring. Overall, have only noticed a minimal difference. |
|
Quoted:
Well I installed it (Which was very easy) and retracting the slide was kinda....hesitant or sluggish is the word im looking for I guess. Ran two mags thru her and its much better. Reset is more positive and trigger breaks cleaner. Cant feel a weight difference but that's because I didn't change the spring. Overall, have only noticed a minimal difference. A connector alone you may not notice a lot of change except for a mushy clunk feeling when the striker breaks and is released. |