Posted: 7/14/2011 6:19:37 AM EDT
| Would someone be so kind to post what parts are compatible or able to swap on a Gen3 and Gen4 and vise versa in each caliber. If I knew I would and I'm sure this would be greatly appreciated by all. |
|
Gen 3 trigger bars are changable with a gen 4. Recoil springs are if you buy the adapter.
All other parts will fit, with the exception of the ejector housing. The Gen 4 has a slimmer housing for the slimmer grip. Not sure on the extractor and plunger. I changed several parts out on my Gen four. I have a G27 so the recoil spring/rod was not an issue. Same as the Gen 3. I used a Gen 3 smooth trigger bar, trigger spring, connector from a Gen 3. Dave N |
|
We just discussed this. This should help:
Differences between Gen3 and 4 Model 19 |
|
But is that the same for the 22,23,21? I see it says G19 |
|
Quoted:
But is that the same for the 22,23,21? I see it says G19 Not all of it will be, but its a good start. For the 23 it will defnitely apply. |
|
Quoted:
Quoted:
But is that the same for the 22,23,21? I see it says G19 Not all of it will be, but its a good start. Thanks 
For the 23 it will defnitely apply. |
|
Quoted:
Quoted:
Quoted:
But is that the same for the 22,23,21? I see it says G19 Not all of it will be, but its a good start. For the 23 it will defnitely apply. Thanks
|