[ARCHIVED THREAD] - RPD feed tray

Posted: 12/26/2011 7:15:12 AM EDT

Just received my DSA receiver. Building with a polish parts kit. Semi parts on the way I hope. Looking it over there are a couple of things I don't understand. Does the feed tray just sit in the receiver or is it attached somehow? Also I noticed there is no pin retainer plunger hole (rear take down pin) like on the original demilled receiver. Normal or is the receiver missing a hole?

Posted: 12/26/2011 8:05:33 AM EDT

[#1]

The feed tray is held in place by the same pin that retains the top cover.

No experience with the semi receivers, sorry.

Posted: 12/26/2011 2:44:32 PM EDT

[#2]

That is normal. I have a Wiselite rec. There is no detent to hold the pin in on mine. The rear take down pin was drilled and threaded in the end for a small button head hex bolt. This holds the rear pin in so it does not walk out.

hope this helps.

Posted: 12/29/2011 9:02:29 PM EDT

[#3]

The differences(major ones at least)
the rear takedown needs a detent drilled
bolt rail slots are undersized, done on purpose, denial feature
grip frame rails are too short, done on purpose, denial
barrel pin hole is not drilled

[ARCHIVED THREAD] - RPD feed tray

AK Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - RPD feed tray

[ARCHIVED THREAD] - RPD feed tray