AK Sponsor
Posted: 3/23/2014 2:35:16 PM EDT
|
I've got an NPap on order and i'm already looking at the stock replacement options.
Since krebs adapter isnt in stock I'm looking at the Ace, my question is if i go with the ace block adapter can I only use Ace stocks? The krebs adapter looked to have more mounting points |
| If you get the Ace modular block you can use either Ace stocks, or AR style stocks with this adapter |
|
I just installed the Ace adapter on my new N-PAP and it required a bit of modification due to the two rivets inside the receiver interface. I used a drill press to remove material to make room for the rivets. I also had to source an M8x1.0 bolt to match the N-PAP threads (ideally 16mm long, but 20mm worked fine). I'm using side-folder skeleton stock and it is a nice setup.
As far as I can tell from the pictures, the Krebs adapter would require the same modification to fit around the rivets. |
|
my e-mail: [email protected]
Just e-mail me with pictures of the side receiver where the stock meet the body (with and with-out the stock attached) and with what kind of stock your looking for. |
|
Here are a couple shots of the rivets in the stock interface on my N-PAP and the modified AKRBY adapter.
http://i103.photobucket.com/albums/m148/mrvco/npapstockinterface_zps6dea4ae6.jpg http://i103.photobucket.com/albums/m148/mrvco/AKRBYAdapter-modified_zpsba7241ca.jpg |
AK Sponsor