Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
16855 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
RS
vortex
magpul
bravocompany
JRH
springfield
skd
aim
palmetto
brownells
midwest
Holosun
CA
geissele
cz
colt
Guns
primaryArms
GS
fightlite
DFC
silencerShop
16855 Online
aim
primaryArms
fightlite
magpul
Holosun
colt
cz
springfield
silencerShop
palmetto
bravocompany
skd
brownells
geissele
Guns
CA
JRH
vortex
GS
RS
midwest
DFC
AK Sponsor
Sponsor News TNVC: NEW and Exclusive Filmed SuperGain (FSG) Image Intensifier Tubes & Chimera Pano Giveaway!!
11/22/2008 10:34:06 AM EDT
Years back I had a slant brake put on my SAR-1 by GlobalTrades.  This was back when they had to be permantely attached so it is pinned.  I noticed today that the slant brake moves a little.  I have hard that the removeable slant brakes do move some when installed but I don't think a permantely installed one shoudl do this.  What do you think?

I dont' know for sure but I assume when they put the break on they had to thread my barrel and then they permantely pinned it.  Would I be able to remove the old brake and buy a new removable one and install it?

Do you think this would work?  

Any info is greatly appreciated!

Thanks,

Person24
11/23/2008 7:24:30 PM EDT
[#1]
If the barrel was threaded, you should be able to push in the pin and remove the break.
11/24/2008 4:08:19 AM EDT
[#2]
You would need to install a spring and plunger to keep the removable brake on, unless that was done when the pinned brake was installed.
AK Sponsor
blackhills
fightlite
Pro2A
springfield
ar15com
primaryArms
bravocompany
RS
cmmg
THBRD
Faxxon
ar15com
palmetto
brownells
gray
colt
LAPG
geissele
SAS
silencerShop
CA
LAPG