[ARCHIVED THREAD] - K-Var Stock

Posted: 2/25/2008 11:47:28 AM EDT

Will a K-Var stock fit on a mak-90

Posted: 2/25/2008 4:43:01 PM EDT

[#1]

Yes, but you must sand it down to fit. The MAKs have a thicker receiver than the Euro AKs, which the K-Var stocks are based on.

Posted: 2/25/2008 4:47:18 PM EDT

[#2]

Does it have that retarded anglle cut?

Posted: 2/26/2008 8:21:08 AM EDT

[#3]

height=8

Quoted:
Does it have that retarded anglle cut?

Posted: 2/26/2008 11:46:12 AM EDT

[#4]

I just unbanned a Mak-90 and am in the process of unbanning a NHM-91 and a Poly-tech sporter. You will have to file down the butstock and the lower handguard to make them fit. The pistol grip will fit without any fitting and the upper handgauard might need a little fitting. Hope this helps.

Peter3

Posted: 2/26/2008 7:01:45 PM EDT

[#5]

Thanks for all the input guys.

Posted: 2/27/2008 12:49:10 PM EDT

[#6]

How much sanding does it take? Just using a dremel? I want to put on a KVAR plum stock set for the MAK-90 I just bought, it is straight.

Posted: 2/27/2008 3:35:41 PM EDT

[#7]

I used a file and it took a while to make it fit. The stock is made for a receiver that is 1mm thick and the chinese receivers are 1.6mm thick, so about .3mm on each part of the butstock(mostly from the sides but also the top and bottom). The lower handguard is much easier just hold the handgaurd to the front of the receiver and mark it where it will fit and file it to that spot.

Peter3

Posted: 3/5/2008 10:16:18 AM EDT

[#8]

K-Var makes the stocks just a hair bigger even for the 1mm receivers so you can remove material for the tightest fit possible. My MAK took quite a bit of filing. I recomend starting with a rasp or you will be working forever.

[ARCHIVED THREAD] - K-Var Stock

AK Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - K-Var Stock

[ARCHIVED THREAD] - K-Var Stock