[ARCHIVED THREAD] - Safety lever and trigger problems

Posted: 1/14/2007 3:19:30 PM EDT

While disassembling my Yugo M70 fixed stock in order to clean it, I pulled the bolt back without moving the safety lever from safe to fire. What resulted was my safety lever sticking up in the air like a mail box flag. I was able to take take out the safety lever and then cleaned the rifle. When I reassembled the rifle, I didn't do something correct because now I can pull the trigger once but I have to manually have to push it back to the fire position. I'm assuming I didn't put the safety lever back into the proper positon. Any suggestions on how to resolve this would be greatly appreciated. Thank you all.

Posted: 1/14/2007 6:45:24 PM EDT

[#1]

I don't think that is likely. Did you knock one of the hammer springs tails off the arms of the trigger. Check the tacked thread at the top of the troubleshooting forum. Did it function prior to this or was it new and you just disassembled it without previously firing?

Posted: 1/15/2007 6:04:11 AM EDT

[#2]

Mak--I bet I knocked one of the hammer springs tails off the arms of the trigger. There was no problem prior to this. Since I'm new to AKs, I don't have to guide to follow to determine where the hammer spring goes. Are you aware of a diagram I can follow, or walk me through it? Thank you very much for your response.

Posted: 1/15/2007 12:55:26 PM EDT

[#3]

ak47.net/content/guides/assembly/akFCG/

www.gunsnet.net/Linx310/fcgremoval3.htm

Posted: 1/15/2007 2:58:41 PM EDT

[#4]

Mak--
I got it and It worked! Thank you very much for your help and your patience with a new guy!!

[ARCHIVED THREAD] - Safety lever and trigger problems

AK Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Safety lever and trigger problems

[ARCHIVED THREAD] - Safety lever and trigger problems