Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 1/18/2006 5:52:01 PM EDT
Will a lower handguard off a milled receiver work on a stamped receiver?

Thanks.

Bud
Link Posted: 1/18/2006 5:56:39 PM EDT
Link Posted: 1/18/2006 6:14:47 PM EDT

Originally Posted By Templar:
Usually yes with little or no problems.

You'll probably have to fit the lower to the receiver a little though.



When i fitted the Romanian lower forend to my Bulgy Milled gun, i had to do quite a bit of fitting to
get it right. It wasnt that bad, but you have to shape the lower tab in the rear of the forend to get it to fit properly in to the spot in the receiver.
You will have to do a little more inletting if you have the metal piece that covers the rear of tthe lower forend that goes into the receiver. Its not hard to do. Use a sharp 3/8" wood chisle to do the fitting and take your time.

KyARGuy
Top Top