AK Sponsor
Posted: 1/31/2005 9:56:08 AM EDT
| does anyone on here know where I could find one?I have searched high and low,Tantels appears to carry them but I can not get a reply,Andyarts(ebay)his ebay store is closed down.Has anyone ever seen these anywhere as part of a kit? |
|
If you want it now, an alternative is to buy the Russian skeleton stock from K-VAR and get all of it done. Then buy the polymer buttstock from RUSMILITARY when he has them back in stock. The only noticeable difference is the pivot pin diameter. The K-var unit uses a smaller pin similar to the Bulgarian and the Russian stock uses the larger pin. All that has to be done is to enlarge the top hole on the rear block, slim down the buttstock a bit and make a custom sized pin. I did this on my 105 clone (effectively except I started with a 74s folder kit) and used the entire Russian set up on my 101 clone. Here's some pic's if you wanna see: AK105 AK101 |
| no, everything went smooth, i would buy from him again. the only issue is you don't really know the exact price till it posts your cc. they sell in british pounds and it's converted at somewhere around 1.82 pounds to the dollar. It took around 10 days or so, you might want to email him for availability, but I think his site is updated. |
|
"hard", that's a relative term. I think it's not hard but someone else might think it very hard. Lot's of guys send their builds out to be done, I can build, (rivet, park, press and coat) a fixed stock gun in an afternoon. But, no instructions as far as I know. There are commonly available templates to assist in the operation. Here's what the cuts look like:  
|
AK Sponsor