AK Sponsor
Posted: 12/16/2013 6:57:48 AM EDT
|
Hello guys,
Can a SLR 95 accept the 2 tang milled Arsenal stock set that KVAR sells (the same one the SAM 7 is shipped with)? Thanks all in advance. |
|
NO.....you have to purcahse and install a lower tang. Some of the 95's had the lower/rear of the receiver milled out for a tang, but most did not.
I milled out a Bulgy lower for a tang myself once. I used hand files. I just did it over a few days while watching TV. 
|
|
well technically, yes, but like Tactical said, you won't have the lower tang, so you won't have the support, and you will have a hole milled in the bottom of the stock for no reason. They do have single tang stocks out there though. If you want wood, look at Ironwood Designs. |
|
Quoted:
well technically, yes, but like Tactical said, you won't have the lower tang, so you won't have the support, and you will have a hole milled in the bottom of the stock for no reason. They do have single tang stocks out there though. If you want wood, look at Ironwood Designs. This.....but I say if you're going to do it.....do it right the 1st time. A properly converted SLR-95 is Sweet, even with the pinned on brake. Riveting the lower tang is the correct way, but I've seen guys srew the lower tang on as well. |
| Not necessary except for visual fulfillment. I stuck a Bulgy buttstock on a similar rifle & never installed the lower tang in 2002. 11 years later, all is well. If my receiver had been cut out for the lower tang, I would have installed it, but to me, it wasn't worth the effort. I still have the lower tang from Global Trades. [Arsenal USA]. GARY |
AK Sponsor