Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
AK Sponsor
7/11/2011 4:56:04 PM EDT
I'm wondering if this will be an issue when getting an Optic for my SGL 31...

It's hard to see, but the side rail appears to be a tad off - the rear end of the rail is resting slightly lower than the front part of the rail.

Should I be concerned? Or do you think I'd be able to get by that by adjusting the sight to compensate for the mis-alignment?

Maybe it's not that big of a deal, but I thought I'd run it by you guys first for opinions.

http://i1081.photobucket.com/albums/j352/javaman85/AKsiderail.png
7/11/2011 5:15:59 PM EDT
[#1]
The side rail is attached correctly. Mine is exactly the same.
I use POSP 4x scope, and the reticle needed negligible elevation and windage adjustment from it's factory set center.
7/11/2011 5:26:02 PM EDT
[#2]
Quoted:
The side rail is attached correctly. Mine is exactly the same.
I use POSP 4x scope, and the reticle needed negligible elevation and windage adjustment from it's factory set center.


Good to know - I think I only really noticed it when I slid a cheap UTG rail on there and noticed the picatinny rail was not totally level with the top of the dust cover. Only then did I notice it.
AK Sponsor