AK Sponsor
Posted: 11/10/2008 6:54:54 AM EDT
|
Hey Guys-
Opened up the Tapco G2 trigger set and thought there would be detailed instrucions on how to remove the trigger and install G2 
Not so !! Does anyone have a link or know where I can get a detailed instructions about removing the trigger and re-installing the G2 Tapco trigger?? Thanks John |
|
FCG replacement
Get a lot a band aids and triple antibiotic... 
|
|
It's a lot easier to use a flat blade screwdriver to push the Shepard's Hook (wire retainer) down just forward of the trigger pin until it clears the groove and then withdraw the trigger pin. You can then rotate the Shepard's Hook up and out of the groove on the hammer pin and remove the pin. It takes about 45 seconds to do it and will save you a lot of grief.
Assemble in reverse order, as the saying goes. |
| My Yugo UF fell apart this last weekend and I have learned on another thread that it is probable because the shepards hook broke and allowed the hammer and trigger retaining pins to back out. What is the easiest and/or most permanent way to fix this problem –– shepards hook, retaining plate, e-clip? Are there any other options? |
|
Hi Guys,
I have been sitting here looking at diagrams and working on the Yugo. I'm still looking for an exploded view of the stock spring/hinge so I can fix that. Where can I get a retaining plate, or even a shepards hook? I really don't want this to happen to me again. I took a lot of crap from my pheasant hunting buddies after bragging about my new AK47 and then having this happen while one of them was shooting the gun during the annual hunting reunion. |
|
For some reason I had one heck of a time getting the trigger and springs out
Assembly went a little faster with minimal loss of blood and pinched hand 
Afer putting the hole thing together I took the rifle to the range and noticed the trigger pin and hammer pin started backing out  I happen to have some of
my screw drivers and manipulated the shepards crook to lock into the slot portion of the retainer pins and everything is good to go 
Took about 3 hours plus 10 mins at the range 
I put the whole thing back together using the G2 Tapco FCG and now the trigger pull is excellent,no trigger slap and this little rifle shoots amazing well !! Thanks for all the pics and advice 
John |
|
Quoted:
Hi Guys, I have been sitting here looking at diagrams and working on the Yugo. I'm still looking for an exploded view of the stock spring/hinge so I can fix that. Where can I get a retaining plate, or even a shepards hook? I really don't want this to happen to me again. I took a lot of crap from my pheasant hunting buddies after bragging about my new AK47 and then having this happen while one of them was shooting the gun during the annual hunting reunion. Plate Most of the popular AK sites (e.g., Copes Dist.) should sell them too. |
|
Don't know if it's still there (assume so), but at the Tapco site there was a downloadable set of isntallation instructions. Don't recall it had anything about removal though.
It's not the same one I remembered, but: http://www.tapco.com/html/instructions/G2%20Instructions.pdf |
AK Sponsor