AK Sponsor
Posted: 10/14/2008 8:51:16 PM EDT
|
Some of you may have read my earlier thread here: www.ar15.com/forums/topic.html?b=4&f=64&t=110266 Finally got a replacement rifle after waiting three months and it has the exact same problem!!!  So my question is, how important is it that the right receiver rail be spot welded down the full length? On my Vector 7.62 it is tack welded in what looks to be four spots. How difficult would this be to fix locally by someone who knows how to weld?
|
| Exact same problem: front half of right receiver rail can be moved up and down with finger pressure. In other words, only the back half is spot welded, the front half is free to flex up and down. The rifle is still at my dealer. If I decide to pick it up tomorrow, I'll try to get pics. "Full length" weld is my mistake. I know the rails are only spot welded. If it's no biggie, then I'll gladly keep the rifle - it really is nice looking. Anyone with a -74 clone that can check your right receiver rail? |
|
uh, then spot weld and refinish. It's going to cost quite a bit if you dont have the tools and cant do it yourself. Here's a tutorial and the tool you need www.surplusrifle.com/shooting2005/souptonuts3/index.asp One option is to post in your hometown forum and see if someone nearby has a modified spot welder for AK building that they would let you use for your two spot welds. Another option would be to drill through the side if the receiver, but not through the rail, and MIG weld. Either way, the receiver is going to need to be refinished afterwards. I would get the original manufacturer to make it right. Three months isnt that long. |
| I don't think it has to be spot welded, a mig welder might be able to it. They're perfect for sheet steel. I don't think it would be a that expensive for a local welder to fix it. I don't own a stamped AK so I can't see how difficult it is or how much of a bead can hold the rail without getting in the way of the bolt. A good welder shouldn't have a problem. Have it welded and send them the bill, Doubtful they'll pay it but it's worth a shot. Hope this helps? |
There is possibility that the surfaces of the rail and receiver that contact each other are parkerized. Surfaces to be joined by resistance welding have to be clean, not oxidized, parkerized or painted. Return the rifle to the manufacturer. |
|
Thanks for the suggestions. I may end up having to return it. Again. Oh, and it was an AUSA receiver. But still wondering, exactly how critical is it to have the front two spot welds done? I know the bolt rides on these rails, but being in the bolt carrier, I wonder what could happen if I just leave it. |
|
The dimple and magazine cut-out area is the weakest part of the receiver. During fire the receiver flexes. The rail also acts as the reinforcement in that particular area. Rail on 7.62 receiver is welded in 3 spots above the dimple due to the more powerful cartridge. For riding or guiding the bolt, one weld or none would suffice. |
AK Sponsor