Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 5/10/2003 10:36:05 AM EDT
OK, I've figured out that the top knob adjusts elevation and the side knob adjusts windage.

If the point of impact is below the point of aim, do I adjust elevation up or down? It seems logical that if it is too low, the chevron should go up, but I get the feeling it may be backward with this.

I discovered that a mechanical boresighter does not work since the front sight tower gets in the way.

I guess it would help if I had a spotter, but I don't, it's just me.

TIA
Link Posted: 5/10/2003 10:40:26 PM EDT
I don't have your type of scope, just a PSO 1, but... get the rifle on a rest, get the reticule on a target, crank a knob (count your clicks so you can return), see which way the reticule moves and then which way you have to move the muzzle to get back on target.
Link Posted: 5/11/2003 10:17:49 AM EDT
Thanks. So, if I were to point the rifle towards the top of the target holder and I get hits on the bottom of my target, I should move the reticle up?
Link Posted: 5/11/2003 6:05:58 PM EDT
Clockwise moves the point of impact about 1cm left or down at 100m, depending on the knob chosen.
Link Posted: 5/12/2003 11:10:21 AM EDT
Thanks, but I'm still confused.

OK -- I'm aiming at 100 yards. I'm pointing the intersection of three lines at the very center of my target. I fire and it hits the dirt. 1- do I move the POI up? 2 - do I move the POI down?

If the shots are going low, do I chase after them (down) or do I adjust by going up?

Thanks!
Link Posted: 5/12/2003 1:50:47 PM EDT
Top knob counterclockwise to move the point of impact up to your point of aim.
Link Posted: 5/12/2003 4:41:51 PM EDT
Great! Thanks a lot!
Top Top