Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 1/23/2006 11:43:34 AM EDT
I am tempted to try one but dont want to waste my time if the are crud. Found a guy that has 80% easy bends with rails, screws, receivers and shipping with instruction for $64....Figured I migh give it a shot . Will make for a darn cheap romy.


OMP

Link Posted: 1/23/2006 11:56:50 AM EDT
If these are the laser cut ones, understand that there is a lot of welding to finish them (and you have to be careful not to warp it), as well as trimming due to the flat being thicker than the common 1mm...(the safety, front trunion, and rear tang won't fit because they are designed for a 1mm thick receiver)

If you really want one, I have one here I would part with for way cheaper than that... IM me if interested.

Top Top