Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 12/28/2005 5:42:06 PM EDT
I am working on assembling my underfolder. I have all the holes drilled in the front of the receiver and have put in the two front rivets with my bolt cutter riveter. However, in putting in the second rivet, I accidently nicked the inside of the trunion. It is just a small nick perhaps ths size of a pencil lead. I assume this will be ok. I probably just need to slightly dremel it down so the barrel does not catch on it when I install. What are your thoughts?
Link Posted: 12/28/2005 6:12:20 PM EDT
Nicked the trunion, eh? I wouldnt necessarily go as far as using a dremel tool. It wouldnt hurt it...i'd just take a little piece of high grit sandpaper and smooth out the burr.. (if there even IS a burr) Dremel seems overkill to me.
Top Top