Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
AK Sponsor
8/23/2008 7:47:53 PM EDT
Hey everyone, any suggestions or tips on a Polish Underfolder build? I hear they are a bit tougher to do. I don't know much about AK builds and was wondering if the flat needs to be any different. I have searched a bit on the internet but have not seen anything specific for this model.

I no longer have high speed internet, I am in the country and decided that a backyard 200 yard range is more important than good internet. I am starting to question my decision though since it's taken me the entire NASCAR race to figure out there is no DIY threads just specificaly for a polish underfolder!
8/24/2008 4:55:46 AM EDT
[#1]
You could always trade me even up for a rommy kit.
8/24/2008 6:35:59 AM EDT
[#2]
Everything is pretty much the same as a Romy other than the underfolder stock installation.  Get on youtude and watch buildyourownak videos.  They give you a pretty good idea of how it needs to be done.  The underfolder installation in on several websites.  Pm me with anymore specific questions and I will try to answer them.  Take care.
8/24/2008 7:07:56 AM EDT
[#3]
Thanks for the youtube tip, like I said internet here is slow and spotty at best. I can do some basic searching but it takes an entire night, video's are impossible. I'll have to go into town near a cell site and take my laptop with me and check out the videos. I think I can save them to the hard drive.
8/24/2008 8:07:59 AM EDT
[#4]
The only real diff in building a Pol UF compared to a romy G is the bottom rivets on the UF are a longer reach. If you have home made 18" bolt cutter rivet squeezers, they won't reach. You'll need a better tool to get to those bottom ones.
8/24/2008 8:13:30 AM EDT
[#5]
Here's a good site for new builders.

Builder Link Site

Too bad the web page won't be there much longer...
AK Sponsor