[ARCHIVED THREAD] - Question on oiling trigger assembly/pins..

Posted: 12/4/2008 10:32:55 AM EDT

Hey all (and QUIB specifically :) )..

I just installed some KNS anti-walk pins, and, wondering about their "keep well-oiled" instruction, I called them up. They recommended a spray of rem-oil into the trigger area after each use. (There's a Jewell in there now).

I currently use Breakfree CLP as my general cleaner in my AR, but have never really messed with the trigger area (it's been a stock trigger and pins up until now.)

So, what do you guys recommend, taking into account all these factors- KNS, Jewell, Breakfree, and Rem Oil?

Thanks!
-BB

Posted: 12/4/2008 12:00:44 PM EDT

[#1]

just use bf clp.

Posted: 12/4/2008 2:59:35 PM EDT

[#2]

Thanks. QUIB, any thoughts?

Posted: 12/4/2008 11:32:15 PM EDT

[#3]

Odd they reccomend Rem Oil because it is not a very good lube. Breakfree is far better. Slip 2000 and Weapon Shield CLP's are even better then Breakfree. Any of the 3 would do the job well. Clean and relube after every shoot!

Posted: 12/5/2008 1:42:09 AM EDT

[#4]

IBQ

As suggested, stick with CLP and your just fine.

Posted: 12/6/2008 4:55:38 AM EDT

[#5]

Quoted:
QUIB, any thoughts?

CLP will work fine.

I wouldn't go crazy spraying it into the lower, that's just a waste of lube and a mess. Just apply sparingly as you normally would with any trigger.

Posted: 12/6/2008 10:05:49 AM EDT

[#6]

Thanks

[ARCHIVED THREAD] - Question on oiling trigger assembly/pins..

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Question on oiling trigger assembly/pins..

[ARCHIVED THREAD] - Question on oiling trigger assembly/pins..