[ARCHIVED THREAD] - A2 Stock Removal

Posted: 2/23/2007 10:46:30 AM EDT

Okay I could not find anything in the archive/search so here goes. I am trying to remove the stock on my RRA CAR-14 with solid A2 stock, I am unable to get the top flat head screw in the buttstock out. Is there a trick or a special tool? I tried my largest flathead screw driver but I cannot get it to budge - and it started to munge up the screw so I stopped. Any hints or suggestions will be greatly appreciated.

Posted: 2/23/2007 12:02:08 PM EDT

[#1]

Heat up the screw. The screws when new have a type of thread locker applied, so removing them at a later date can sometimes be a PITA.

Posted: 2/23/2007 3:27:46 PM EDT

[#2]

I had the same problem on one of mine. I bought an armorers wrench that has a screwdriber built in that fits prefectly.

Posted: 2/23/2007 5:52:43 PM EDT

[#3]

put the lower in a vice, use push and turn with a big screwdriver.

Posted: 2/26/2007 4:38:09 PM EDT

[#4]

Quoted:
put the lower in a vice, use push and turn with a big screwdriver.

[ARCHIVED THREAD] - A2 Stock Removal

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - A2 Stock Removal

[ARCHIVED THREAD] - A2 Stock Removal