AR Sponsor
|
Thank you all for the advice; I certainly won't use crappy ammo anymore (even with this cheap plinker build).
I've tried a few times to tap it out without success; I'll try lubing each end for 24 hours and give it another whirl! PS - I am applying good safety practices to this work. |
|
was it assembled into a firearm?
did you do the correct "mortar" proceedure to eject a stuck round? I've never understood everyone being quick to suggest putting a rod down the bore to push out a stuck case or round, the potential for damage to the crown and bore is extremely high and should be considered an absolute last resort. |
|
Step 1 take a gi cleaning rod
Step 2 ram it down the barrel ! Bullets can't set off the powder! Hitting the primer can ,so don't poke at primer! Man up don't be a pussy for god sake ! Your not going to ruin the crown. You all act like your freaking snipers or match shooters and little girls ! |
|
Quoted:
Step 1 take a gi cleaning rod Step 2 ram it down the barrel ! Bullets can't set off the powder! Hitting the primer can ,so don't poke at primer! Man up don't be a pussy for god sake ! Your not going to ruin the crown. You all act like your freaking snipers or match shooters and little girls ! Thanks for the tip, this worked like a champ (better than the wood dowels I tried w/ earlier). Thank you all for your advice, no more cheap ammo for me... |
|
Quoted: Thanks for the tip, this worked like a champ (better than the wood dowels I tried w/ earlier). Thank you all for your advice, no more cheap ammo for me... Quoted: Quoted: Step 1 take a gi cleaning rod Step 2 ram it down the barrel ! Bullets can't set off the powder! Hitting the primer can ,so don't poke at primer! Man up don't be a pussy for god sake ! Your not going to ruin the crown. You all act like your freaking snipers or match shooters and little girls ! Thanks for the tip, this worked like a champ (better than the wood dowels I tried w/ earlier). Thank you all for your advice, no more cheap ammo for me... |
AR Sponsor
