Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
7014 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
aim
geissele
fightlite
Holosun
colt
primaryArms
brownells
DFC
cz
vortex
skd
palmetto
GS
midwest
bravocompany
springfield
magpul
RS
Guns
JRH
silencerShop
OSIGHT
7014 Online
DFC
skd
silencerShop
midwest
vortex
GS
geissele
palmetto
colt
primaryArms
magpul
aim
springfield
Holosun
OSIGHT
JRH
bravocompany
RS
fightlite
Guns
brownells
cz
AR Sponsor
Sponsor News Introducing TNVC's NEW and Exclusive Filmed SuperGain (FSG) and Chimera Panoramic Goggle Giveaway!
Site News The People of Virginia VS Grabigial BanBerger | ARFCOM News
11/26/2009 6:23:18 PM EDT
So I purchased a Tapco FS tool, I go to adjust the FS and it does not push down the spring loaded pin so that I can adjust the sight... So I have to push the pin down with a screwdriver in order to adjust the sight....   So what is up with this??  TIA
11/26/2009 10:13:48 PM EDT
[#1]
There is the A-1 front sight tool, and then the A-2 sight tool (different number of prongs since each sight has a different number of notches).

If the prongs match on the sight and tools, then chances are the tool is not mating correctly with the notches to allow the tool to flush out with the top of the sight.
12/5/2009 11:24:25 PM EDT
[#2]
Have seen quite a a few sight tools that aren't deep enough to accommodate the height of the post.
12/6/2009 3:35:44 PM EDT
[#3]
Use the tip of a FMJ to drpress the front sight detent pin and rotate the sight post.......

Works every time!
AR Sponsor
ar15com
CA
SAS
colt
RS
blackhills
silencerShop
gray
ar15com
primaryArms
brownells
springfield
ar15com
Pro2A
LAPG
bravocompany
palmetto
Faxxon
LAPG
geissele
THBRD
fightlite