AR Sponsor
Posted: 4/29/2009 10:37:24 PM EDT
|
Model1Sales 16" upper (assembled by M1S), RRA lower w/ 2stage trigger, assembled by me. Load the Pmag with a few rounds, install mag in AR, pull the charging handle back, and the round gets stuck on barrel extension. That guides the tip of the bullet into the barrel. Should I run a few rounds through it, the gun still hasn't been fired?
http://www.midwayusa.com/mediasvr.dll/image?saleitemid=169485 |
| where exactly is it stuck on thee barrel extension? if stuck between the 2 bullet guides then I assume its the barrel extension, but that is rare. If stuck just below the bullet guide, then try a different mag like an mil-spec alloy mag. Any new rifle shouldnt be doing this at all. Check for burrs on the follower and lips of the mag. |
|
Quoted:
Are you riding the charging handle back down? If so, do not do that. Pull back and let fly. If that isn't what is happening then carry on. yea it is the barrel extension I am riding the handle. I tried cheap monarch .223 and remington and 5.56. I took the upper off and it catches even when I use my finger to load the bullet. |
Loads the round on the right, but not on the left. When I let the charging handle fly back. 
http://i26.photobucket.com/albums/c138/big_tiger19/AR-15/IMAG0044.jpg |
AR Sponsor