AR Sponsor
Posted: 4/5/2007 4:51:28 AM EDT
|
Allright, so I've bought a stripped lower reciever(RRA) and a LPK (again, RRA) and RRA stock and put them together last night. This is my first time doing so, but I'm not sure if I did everything correctly, especially around the trigger/hammer area. While doing the function test, it seems like sometimes it would pass, and other times it wouldn't. Problem is when I pull the trigger, hold the trigger down, recock the hammer, and as I release the trigger, the hammer would pivot forward again. Now, I'm not sure what could be doing this, as it dosen't happen all the time. Any help would be appreciated. I'd test fire it at the range but 1)my upper is still a few weeks away and 2)I'm afraid that it'll go FA at the range and I'd like to avoid that. |
The "hook" on back of hammer should catch the disconnector (secondary sear) when trigger is pulled and weapon cycles. When u leave go of the trigger, the hammer should fall onto it's primary sear (located on bottom front of trigger piece.) The weapon is now ready to fire. As long as it does this u should be OK. Hope this helps. 
|
AR Sponsor