Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 2/7/2006 11:15:05 AM EDT
[Last Edit: 2/8/2006 5:00:32 PM EDT by VT4meGunCtrlisAntiUS]
I just received a 11.5/ 5.5" A2 Bushmaster upper I bought on the EE. I removed the upper from my old BM M4gery and put the new (used) upper on, with a brand new BCG from Bushmaster and my old CH. The CH has the model 1 Badger Ordinance latch on it, and I had to force the BCG into position. I took the CH out (after quite a struggle) and tried the CH from my Bushy 20" A2, and it dropped right in, no problems. Then I tried the CH with the BO latch in my 20" A2, again smooth.

I guess my question is: Why won't the 11.5/ 5.5" upper accept the CH with the BO latch, while the other 2 uppers will? I can push it all the way in, but then it's very difficult to remove.

Thanks for the help!

--VT
Link Posted: 2/7/2006 12:22:07 PM EDT
[Last Edit: 2/7/2006 12:22:53 PM EDT by Dano523]
Link Posted: 2/7/2006 3:01:16 PM EDT
Dano-
for some reason the CH with the tac latch gets hung up about 1/2 inch from being fully seated. The other CH with a BM factory latch does not get hung up. At the same time BOTH of the CH's work perfectly in my other 2 uppers (one 14.5", one 20"). I can't figure out what the deal is.
Thanks-

--VT
Top Top