AR Sponsor
Posted: 8/16/2005 5:20:31 PM EDT
|
With it fully extended, 1st shot sends it fwd two posistions. If I set it on the 3rd one out it does not do act as such, only in the 4th one, fully extended out. Should I just ditch it and get a new one? Or is there something I can do with the pin to make it longer? Or the plastic may be worn? It has about 3k rounds through it. |
|
Sorry, I guess that would have helped... This one DPMS I got it through some vendor in SGN. |
|
The DPMS stock I bought had a short spring that held little to no pressure on the pin when it was in a hole. When I took it apart I found the plastic was drilled so deep it worried me it was not thick enough to stand much use or the installation of a stiffer spring. I did find a longer spring the same size to put in it to give it a little constant pressure. The stock is still in the top of the closet. I never used it because of this. I also had a stock once that the pin wore the aluminum on an angle after shooting for a year or so. It would slide past the hole to the next one when you shot it. I tried running the nut off a little so it would seat deeper in the hole but then after shooting the pin bent because the small portion was to low. I had to cut the pin off to get the stock off because the lever would not retract the bent pin. |
AR Sponsor