Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 10/14/2003 10:00:03 AM EDT
He thanks fo the look, is it normal for a ARMS 22M68 to be able to move to the front and rear. I noticed it when iI was adjustin my scope caps on my Aimpoint. I have a KAC SR15 M4 with 22M68 ARMS cantilever and M2 aimpoint rig. It dose take good pressure to do it but should I be able to move it?
Link Posted: 10/15/2003 6:19:53 PM EDT
Two ARMS#22M68 mounts here - one with the cantilever riser. Absolutely no movement with either.
Link Posted: 10/17/2003 6:44:03 PM EDT
Called ARMS today they said that it shouldn't be loose. They asked me who made my gun and I told them KAC. I was waiting on them to blame it on my rifle but they didn't. They want me to dissasemble my mount and send it back to them so they can check the specs.
Link Posted: 10/17/2003 7:30:32 PM EDT
i had the same problem. turned out the the SIR rail it was mounted on was loosening. i loc tite'd it since i don't plan on moving it anyway.
Link Posted: 10/17/2003 7:38:17 PM EDT
Own two 22M68's and a 19S. Not the least bit of movement in them.
Link Posted: 10/17/2003 8:10:24 PM EDT
FWIW, first time out with the 22M68 was something else... the screws holding the ring to the base came loose! A little loc-tite fixed that... haven't had a problem since. so, while you're putting it on, might I suggest doing the same?
Link Posted: 10/18/2003 11:33:22 AM EDT
It is Loose at where the base attaches to the flat top rail. I did lock tight everything else, but if you lock tight the lever you can't remove it.
Top Top