[ARCHIVED THREAD] - Gas Block Alignment on WOA Barrel

Posted: 11/22/2013 2:10:00 PM EDT

I installed a Troy Ind low pro gas block on an 18" WOA SPR barrel and had to dremel down the gas block a little bit and hammer the sucker on

After I got it all the way down I eyeballed the alignment which looked spot on

But, is there any way to check before barrel install that the gas block is 100% aligned on the barrel?

Thanks for your help

Posted: 11/22/2013 4:10:14 PM EDT

[#1]

i would have measured them twice ( shoulder to gas port and edge of block to port ) then beat it on once

[ARCHIVED THREAD] - Gas Block Alignment on WOA Barrel

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Gas Block Alignment on WOA Barrel

[ARCHIVED THREAD] - Gas Block Alignment on WOA Barrel