[ARCHIVED THREAD] - stag H2

Posted: 6/6/2013 5:44:08 AM EDT

I have a complete New Frontier lower and Midwest PX Premium NiBX AR15/M4/M16 Bolt Carrier Group that I bought from Midwest Px.

I just ordered a Stag Arms 16" M4 Upper Half (w/ BCG & MI ERS) from Bravo Co. that includes a bcg. I am greener than a gourd on AR15 builds, is this ready to just assemble to the lower I have?

Should I use the included bcg or replace it with the Midwest PX bcg? I already own a DPMS ar, but bought it as a complete rifle. and haven't taken it apart. Any advice would be appreciated.

Posted: 6/6/2013 6:05:15 AM EDT

[#1]

Yep, clean it and pin it.....hope to see your next post in a couple of years...

EDIT I would use the Stag bolt

Posted: 6/6/2013 6:16:37 AM EDT

[#2]

I see you noticed I've been a non speaking member for a while. Just read and keep my mouth shut.
I am pretty sure I will have more questions

Posted: 6/6/2013 8:31:10 AM EDT

[#3]

Quoted:
Yep, clean it and pin it.....hope to see your next post in a couple of years...

EDIT I would use the Stag bolt

Posted: 6/6/2013 12:09:04 PM EDT

[#4]

Let me get this straight, just to make sure.... When I buy a complete upper, it has been head spaced and is ready to go???? Just need to add magazine and ammo???

Thanks

Posted: 6/6/2013 1:11:54 PM EDT

[#5]

Yep, I have 2 Stag uppers a 1H and a 4H. Gave them a bath, slapped them on the lowers and went to the range...Make sure you do your function checks prior to going hot..Then load a single round in the mag and see if it goes bang..I then do two, then five . If things go out of control, I don't need a shitpot of rounds going off. If things are GTG, light it up!!!!

Posted: 6/7/2013 3:37:09 AM EDT

[#6]

Thanks for the help. Now I have a left over bcg. So the only thing to do is try to find the rest of the parts, I can't just let it sit in the safe room....

[ARCHIVED THREAD] - stag H2

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - stag H2

[ARCHIVED THREAD] - stag H2