AR Sponsor
Posted: 1/12/2013 6:27:30 AM EDT
| I recently put three stripped lowers together following instructions that I found here as well as watching youtube videos. All of them show doing a trigger/hammer function check prior to installing the safety selector. Not one of mine has worked like this. The hammer locks in place; releases when pulled; but when I hold the trigger in place the hammer will not latch. It almost appears that the trigger is leaning too far forward with the trigger pulled and the hammer bottoms out on it. This is also a bit evident when I go to install the selector as I need to push the rear of the trigger down to get it though. Once the selector is in place though the trigger/hammer function tests as it should. What am I missing? |
AR Sponsor