AR Sponsor
Posted: 11/1/2012 7:27:52 PM EDT
|
Guys,
I see these tools all over the net: 
Then I see reviews on them saying the powder coating is too thick, or the dowel pins for the barrel nut are the wrong spacing... Then some guys say they have received perfectly good tools. These all appear to be imported from the same company based on design and coloration. Is there a known good source on these? |
|
Here's the best $40 (shipped) armorer's wrench on the market, IMO.
Gem State Armory I just used one for the first time and it was outstanding.....very high quality tool. Comes with two wrench "heads". The scalloped one seen in the pic will do USGI barrel nuts up to NM float tube diameter. There is an improved, 3 pin USGI that also ships with the wrench. The heads can be used on the right or left side of the wrench. Other heads can be ordered for 308AR etc, etc. Made in Idaho, USA. |
|
Quoted: Here's the best $40 (shipped) armorer's wrench on the market, IMO. Gem State Armory I just used one for the first time and it was outstanding.....very high quality tool. Comes with two wrench "heads". The scalloped one seen in the pic will do USGI barrel nuts up to NM float tube diameter. There is an improved, 3 pin USGI that also ships with the wrench. The heads can be used on the right or left side of the wrench. Other heads can be ordered for 308AR etc, etc. Made in Idaho, USA. This ^^^ Great tool. I thought this AR wrench can do the .308AR? |
AR Sponsor