AR Sponsor
Posted: 9/24/2011 2:27:36 PM EDT
Are there any special steps I shoud take to install a Dynacomp Brake on my rifle? It's a 16" middie with a standard A2 FH, non-pinned, so pin removal is not an issue. Any special torque settings, or just tighten it up (w/blue locktite) with the "bare" area of the comp at 6 o'clock? I know it may be a stupid question, but I never claimed to be an Einstein. 
Thanks. Y'all are the best. John |
| The first place I saw them for sale, they include a crush washer. Usually that means 'hand tighten' and then use a wrench to time/index it. (Bare/un-ported side down, in this case.) I wouldn't use any threadlocker, personally. The crush washer + torque needed to line it up should be sufficient. |
AR Sponsor