AR Sponsor
Posted: 9/7/2011 1:42:07 PM EDT
|
I have built up my four Olympic Arms and I am having problem inserting and removing. Any clue how to fix.
Bob |
sorry wrong forum.
|
Quoted:
 that's funny. Inserting and removal of the mag.
Rob Maybe you didnt push the mag release button in far enough while you were screwing the mag catch/release in the reciever? You can push the button in with something like needle nose pliers because its hard to push it as far in as you need it to get the screw part flush with the button. Kind of hard to follow what I wrote I think, but there are pictures here on the forum. |
|
Well if it isn't the mag catch then that only leaves undersized mag wells. Are they consecutive serial numbered lowers (or real close) ? Remove the upper, take the mag catch completely out of the lower, if the mags don't slide in and out freely then the mag well is undersized. If they do slide fine then it must be something with the mag catch. |
|
Quoted:
Well if it isn't the mag catch then that only leaves undersized mag wells. Are they consecutive serial numbered lowers (or real close) ? Remove the upper, take the mag catch completely out of the lower, if the mags don't slide in and out freely then the mag well is undersized. If they do slide fine then it must be something with the mag catch. that's it +1 |
|
Quoted: Going to have to try it when I get home again. End of this month. Receiver is consecutive serial lower. Anothe question, does it matter if the lower is not with the upper and you insert the mag? Bob No. It should fit the same with or without the upper attached. I generally buy local. I bought a AP lower that is tight in the well. I now always take a pre modM PMag with me to test first. If it's gtg on a old style PMag it's gtg on anything. |
AR Sponsor