AR Sponsor
Posted: 2/19/2011 6:59:10 PM EDT
|
I just built my first Delton AR and Im very pleased with the result, but when I looked down the sights i noticed the front is extremely crooked. How do you loosen it to adjust it? Its a traditional front sight.
http://i232.photobucket.com/albums/ee10/vdubn_it/DSCN0354.jpg http://i232.photobucket.com/albums/ee10/vdubn_it/DSCN0355.jpg |
|
It's rare that they are canted to the right (as you look down the sights). Are you sure it's not that UTG rail that's making it appear that the FSB is canted? Take the rail off & check again.
Also, how are you confirming that the FSB is canted? Just by eyeballing? Is the EOTech canted on the upper's rail? |
|
If i look down the rail on the upper towards the front sight you can see its to the right. Sorry the picture isnt the greatest quality but you can definately see how its crooked. Should i be calling Delton?
http://i232.photobucket.com/albums/ee10/vdubn_it/DSCN0359.jpg |
| Get a bullet laser and make sure the dot is in line with your post site... Ill try to post a Pic to show you but unless you have a straight edge and a square to make sure its a tru 90 degrees its hard to tell in this pic but I do see the site dosent look perfectlly straight.. |
|
Quoted:
If i look down the rail on the upper towards the front sight you can see its to the right. Sorry the picture isnt the greatest quality but you can definately see how its crooked. Should i be calling Delton? http://i232.photobucket.com/albums/ee10/vdubn_it/DSCN0359.jpg Yeah that doesn't look right. Get a boresighter. |
AR Sponsor