[ARCHIVED THREAD] - Colt 6920 trigger question

Posted: 12/20/2009 5:02:16 PM EDT

I went to this weekend's guns show and bought a nice two stage trigger and was going to place it into my Colt. Only when I tried to install it did I realize that the trigger was the small pin type. Is there a way to drill out the trigger and make it fit into my colt?

Any suggestions would be appreciated.

Posted: 12/20/2009 6:20:50 PM EDT

[#1]

Don't drill it out. The pin size on your 6920 is .170 I think. You new trigger is probaly .154. You are better off sending your stock trigger to Bill Springfield. The 6920 pin size has been a big issue. I believe their newer rifles come with the small pins now.

Posted: 12/20/2009 6:34:35 PM EDT

[#2]

That is true but there has to be a way to convert the 0.154 to the 0.170.

Posted: 12/20/2009 6:43:25 PM EDT

[#3]

Well if there's a way or a better option this is the place...someone will chime in. I was almost in the same boat but came here first and that's where I found out about Mr. Bill and his work.

Posted: 12/20/2009 7:22:34 PM EDT

[#4]

Sell the trigger (if you can't return it) and buy one made for the Colt pins.

Posted: 12/20/2009 7:47:06 PM EDT

[#5]

Quoted:
That is true but there has to be a way to convert the 0.154 to the 0.170.

Bad idea to try and drill it out. Return it or sell it and buy the proper trigger.

[ARCHIVED THREAD] - Colt 6920 trigger question

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Colt 6920 trigger question

[ARCHIVED THREAD] - Colt 6920 trigger question