AR Sponsor
Posted: 3/13/2009 4:23:15 AM EDT
|
I am looking for the write up on the Safety Selector Detent. You Tap your lower for a Hex Screw and it keeps the spring from flying out if you take your stock off. I think that Spkies dose it. I searched but I didnt come up with any thing.
Thanks MAHA |
|
Are you thinking the takedown pin? I've not seen one for the safety selector. I just did this for a pistol lower. Mine took a 4-40NC tap just like the writeup says. I didn't have a tap that small laying around, but it was only about $4 at Sears for the tap and a drill bit. The 4-40 x 1/8" set screws are a little harder to find - they're smaller than what Lowes/Home Depot and Ace had around here. I ended up going to an industrial fastener supply house, and all they had were 4-40 x 1/4", so I had to trim a few extra coils off the spring to get everything to fit. Oh, and you'll need a 0.05" hex key for the set screw. Not too hard to find, but not all hex key sets have one. |
AR Sponsor