Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
6489 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
OSIGHT
silencerShop
vortex
bravocompany
RS
Holosun
aim
Guns
brownells
geissele
fightlite
springfield
magpul
palmetto
skd
JRH
primaryArms
GS
cz
colt
DFC
midwest
6489 Online
GS
geissele
magpul
brownells
skd
colt
DFC
bravocompany
OSIGHT
aim
silencerShop
springfield
fightlite
palmetto
primaryArms
vortex
Guns
RS
Holosun
cz
midwest
JRH
AR Sponsor
Site News Could You Have Stopped This? Vegas Shooting Analysis with Attorneys on Retainer
Sponsor News Introducing TNVC's NEW and Exclusive Filmed SuperGain (FSG) and Chimera Panoramic Goggle Giveaway!
1/7/2009 6:25:44 PM EDT
I am trying to assemble my barrel and Im putting in a low pro. gas block.  My question is how to properly put on the gas block to where the gas tube hole correctly aligns with the hole on the barrel.  The jig from Rainier would be great but they are out of stock.  And there are also no dimples for the set screws on the bottom of the barrel so its pretty much just a guess when I slide it on.  Anybody have any tricks to install this without a jig?
1/7/2009 6:52:40 PM EDT
[#1]
I've read here of people using a bent paper clip thru the hole for the gas tube.
 I've done it by just measuring and marking the bbl where the gas block should end up and came out OK.
1/7/2009 6:58:08 PM EDT
[#2]
Both good ideas...i like the paper clip one
AR Sponsor
RS
SAS
Pro2A
gray
bravocompany
LAPG
geissele
silencerShop
blackhills
springfield
colt
ar15com
fightlite
THBRD
ar15com
brownells
palmetto
Faxxon
CA
cmmg
primaryArms
ar15com