AR Sponsor
Posted: 10/1/2007 12:09:57 PM EDT
| After leaving the AR builds for awhile to learn how to build AKs (it is a blast compared to the Lego assembly of an AR) I am back to take it to the next level. After searching I did not find the answer to this, but where can I get a 80% lower receivers? And any advice going into this would be appreciated. |
| I would highly recommend the 80% lowers from Kevin. His email can be found over at CNCGuns.com. Send him an email and he'll let you know if he has any in stock. I have used a couple of his with excellent results, every area is done to spec. If i remember correctly, his were going for $125 shipped. But check with him. And good luck. |
|
His name is Justin and you can email him at [email protected] www.cncguns.com Or you can contact him at: Justin Halford JWH Enterprises P.O. Box 16532 Jonesboro, AR 72403 Since he doesn't have a manufacturers license, he only makes them to 10%, not 80%. But if you have the machining capability and tools, he makes a great 6061 billet. |
There is also a link to a guy named Kevin, on the same site, and he does indeed sell 80% lowers and is in fact recommended by Justin. |
On the cnc website, click on tooling at the top. Then scroll down and you will come to a section where he recommends using lowers from Kevin and provides his email address and a few pics of his 80%'ers. on the other hand, you could just email him direct at [email protected] hope this helps |
AR Sponsor