AR Sponsor
Posted: 5/4/2007 9:44:21 AM EDT
|
Does anyone know who sells a low-profile FSB (with rails) that uses taper pins? Thanks |
|
Taper pins holes are drilled and reamed AFTER installation of the front sight base or gas block to the barrel. You are NOT going to find this off-the-shelf because YOUR BARREL is not drilled for it. There is no standardization of taper pin location. If you took your front sight off and tried to put one on that came from another barrel, you would find this out the hard way. Almost ANY gas block/barrel can have a pin added after it's installed by simply cross drilling, reaming and installing the pin. |
AR Sponsor