AR Sponsor
Posted: 2/28/2007 3:22:56 PM EDT
|
I just got my new CTR stock and need to take off my old stock body. Its a standard cmt 6 pos. How do I get it off? ETA: Got it off now how do I put the new CTR stock on? How tight should it be to the tube? Mine seems very snug? |
its been a while and i've only done it once....if i remember right, you simply pull down on the horizontal black tab/round bar and slip it on as it was on the M4--it will be tighter to do so h/w ETA: www.ar15.com/forums/topic.html?b=3&f=12&t=308482 www.ar15.com/forums/forum.html?b=3&f=118 |
|
Do you have a Mil Spec tube? The CTR will only fit on a Mil Spec Tube. What kind of stock did you take off of the rifle?
eta You have to pull the 2 tabs on each side of the release leaver. They look like 2 little metal dowels sticking out on each side right above the lever. |
commercial CTRs are out now--just in the last couple of weeks  but yea, make sure your stock body is suited for your tube |
What alphaghost said......I wasn't aware any other were available but I know from the 2 that I have purchased I replaced the tubes. Fit should be snug but not the gut busting type. |
AR Sponsor