[ARCHIVED THREAD] - AR-10 Lower question

Posted: 12/15/2006 5:36:26 AM EDT

I'm finishing up an 80% AR-10 lower. My question is: Where to spot the hole for the pin that holds the bolt catch? If I had to guess, I'd spot it in the middle of the bosses that it fits between, but it's a lot easier to post a potentially stupid question than to fix a hole that's drilled in the wrong place. Anybody have a link to a dimensional schematic or blueprint?

Many thanks.

Posted: 12/15/2006 3:30:05 PM EDT

[#1]

I have a few PDF dimensional drawings, email me if interested.

Rick

Posted: 12/15/2006 4:01:08 PM EDT

[#2]

Did some searching and here is where I found them...

http://www.cncgunsmithing.com/downloads.html

These guys have a great website with lots of useful information.

Rick

Posted: 12/21/2006 2:22:48 PM EDT

[#3]

Thanks Rick. From those pics, it appears to be centered on the boss. That seems to mike out about right too, so I'm good to go.

[ARCHIVED THREAD] - AR-10 Lower question

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - AR-10 Lower question

[ARCHIVED THREAD] - AR-10 Lower question