Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 2/18/2006 2:48:24 PM EDT
Hi guys.

I plan on adding a YHM free float and I know I will need to remove the barrel nut and delta ring.

Do I need an action block or could I just use a shaped peice of hardwood slid up into the magwell and tightened in a vice.
Link Posted: 2/18/2006 2:59:00 PM EDT
You don't need an action block, but don't do what your talking about. You have to seperate the upper from the lower before removing the barrel, atleast I would highly recomend doing that. Then you can put the upper in a barrel vice or an action block. If you don't have either I would borrow them or take it to a pro to remove your barrel. If you insist on doing it yourself, you might get away with it but then again you might mess something up.
Link Posted: 2/19/2006 3:12:25 PM EDT
Link Posted: 2/19/2006 5:33:12 PM EDT
Teknic is right I am living proof get the block.....you will be using it again.....again.....and again,just started on built #5
Link Posted: 2/19/2006 6:36:16 PM EDT
what the others said, but you need to remove the fsb too.
Top Top