AR Sponsor
Posted: 1/31/2006 12:48:01 AM EDT
|
I've been wanting to ask this for a while now but haven't gotten around to it. I have 2 problems with Norrells. I was hoping that some of you guys who's ARs have turned out a million times better than mine could help me out. Problem 1.) I've got several things I'd like to spray, but it's freezing cold outside. Literally. When the metal is pre-heated everything works great, but when I step outside to spray, the metal turns the same temperature as the air and then the Norrells runs as soon as it hits the rifle. I can't spray inside, it's just not an option. The garage is just as cold. Is there anyway to get around this? Problem 2. ) I've got a long distance bolt gun that I'd like to spray but the barrel itself is 26" long, and so the whole thing won't fit in the oven. Can I just leave the oven door open and turn it broil or something? (I think that was cause uneven heating and turn out pretty nasty) I'm open to suggestions. I appreciate it a lot. Thanks in advance guys. |
|
When I did mine I did it in the garage with the door wide open. Had a large space heater and a hairdryer basically aimed at what I was sprayed. Worked really well. As far as baking.... looks like your going to need to either buy or build a curing oven. A lot of people have built them with old dryer heating elements. -C4- |
|
Steve, Keep the Norrells warm. I use a bucket or a pot filled with hot water. Yes, with a large item you can leave the oven door open, just make sure you swap it so both sides are getting heated. Check for cure when done, and remember that your curing time will increase. A 26" barrel shouldn't be impossible, try removing the racks and putting it in at an angle, then raise the farther side to the top while the other side comes down to the bottom. If its close, try finding someone with a larger oven. |
your genius knows no bounds! |
+1 |
AR Sponsor