Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 12/27/2005 3:25:34 AM EDT
Who is using these .Got one orderd for my project,any hints, tips, tricks for instalation.
Link Posted: 12/27/2005 10:58:05 AM EDT
I've got one on my SPR-ish. To align it I made a very small dimple mark on the step-up of the barrel in line with the gas port. I put the sight on and looking down over the gas tube made sure it was aligned with the mark as I tighteded it. Also, the sight is designed to butt up directly against the barrel step. Here's a pic of the rifle with the sight installed..


Link Posted: 12/27/2005 1:01:04 PM EDT
Is the hole on the gas block a little bit oversize so that you can make minor adjustments in order to align the sights with the rear sight centered?
Link Posted: 12/27/2005 1:34:31 PM EDT
I installed mine using a similar method as Azrael2004. I used a pencil to mark location, and wiped it off when I was done. Went on pretty quickly & easily.
Link Posted: 12/28/2005 6:42:01 PM EDT
Sounds good,Thanks.
Link Posted: 12/28/2005 7:32:17 PM EDT
The only thing I extra I added was some grip compound I had to the lower half of the unit to
inhibit any axial or radial movement of the sight.

I got the stuff w/ a band type shotgun sight. Feels just like valve lapping compound found
in the plumbing section. Some fine grit suspended in grease is all it is.

Keep it away from the gas port, I'm pretty sure it will eat up any moving parts.
Link Posted: 12/29/2005 5:32:35 AM EDT
Top Top