AR Sponsor
Posted: 8/13/2005 9:46:12 AM EDT
| I'm assembling my lower and have run into an issue with the safety catch. I cannot insert it into the receiver. It looks like in the cocked position the end of the trigger isn't low enough down to let the safety through. Any ideas? Is it a bad trigger or (hopefully not) or a misdimensioned receiver? |
|
There were some triggers out that would not let you put the safety in with the trigger in place but that was a while back. I had to drop the trigger in and let it lay in with no pin then insert the safety. Also some brand lowers will let you remove the trigger from the lower with the safety in place and some that will not. |
The lower parts are from SARCO so God knows when or where these parts are from. So it could be an older one like you described. The trigger on my Bushmaster looks different than the SARCO trigger FWIW. I think I will pull the hammer and trigger pins and attempt to put the safety in first. |
|
The edge of the safety is quite possibly hitting the top edge of the trigger rear end. Happens on a couple of my pieces. Push the hammer down w/your thumb as far as it will go, and hold it down while you push the safety in. I've even used a screwdriver to push the trigger aasy down while I slid the safety in. Alternatively, assemble the safety before you put the hammer and trigger assys in. It'll take a bit of maneuvering to get the back end of the trigger under the safety, but it's not a big deal. |
|
Success! Pulled the hammer out of the lower. The trigger was low enough to allow the safety catch through. Reinstalled the hammer and did a function test. Works perfectly. Thanks for the help, going to post a few new problems with the front takedown pin and the buttstock. |
AR Sponsor