Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 11/26/2003 10:25:41 AM EDT
I have a barrel that has an O.D. of .750". at the front sight location. The gas block I bought from DPMS has an I.D. of .747". From what I've read, the gas block/front sight should be a slip fit onto the barrel. This puppy acts like I'm going to need to beat it into place. Will doing this hurt the barrel or the gas block?
Link Posted: 11/26/2003 2:39:00 PM EDT
Horn/ream the block to open it up to .751-3. This will allow you to remove the block in the future.
Top Top