AR Sponsor
Posted: 6/7/2003 5:29:10 PM EDT
| I'm trying to remove my buffer tube to replace it with the MSS-M93, and it just won't budge. So far , just been trying hand tools, trying not to damage the tube just in case. Any hints, do I need an action vise, do I take a pipe wrench to the tube thereby destroying the tube, any help would be appreciated. Or should I just take it to a smith. thanks |
|
Chances are that the receiver extension was loctited. You will need to heat the tube up just before the receiver with a heat gun to break the loctite bond. Once the bond has been broken, then just put a wrench on the end flat and sit on the receiver to spin it off. |
|
Quoted: Thanks everyone, I was wondering when do you know that the Loc-tite has released/melted. What kind of time are we talking about, 10-15 seconds, 2-3 minutes, etc. And can you use a propane torch to gently heat the tube, I know be very careful. Again Thanks You could use the propane torch but you won't need to put the actual flame point on the metal. Maybe get one of those flare thingies that looks like a fan. Get some one to put constant torque on the extension while you gently heat. I'ld say the 2-3 minutes is closer to what you're looking for if going slowly like you should. |
|
Quoted: Quoted: Thanks everyone, I was wondering when do you know that the Loc-tite has released/melted. What kind of time are we talking about, 10-15 seconds, 2-3 minutes, etc. And can you use a propane torch to gently heat the tube, I know be very careful. Again Thanks You could use the propane torch but you won't need to put the actual flame point on the metal. Maybe get one of those flare thingies that looks like a fan. Get some one to put constant torque on the extension while you gently heat. I'ld say the 2-3 minutes is closer to what you're looking for if going slowly like you should. Better yet, use a heatgun (basicly a HD hair dryer). If you use a torch, just be careful not to over-heat your receiver. This is where you really need two people. If you have a junker mag, insert it into the mag well and clamp the mag in a vise. Have your buddy apply moderate torque to a wrench on the end of the buffer wile you are applying heat to the receiver (not the tube). It will break loose and spin easily once you reach the proper temperature. |
AR Sponsor