AR Sponsor
Posted: 9/2/2002 4:32:52 AM EDT
|
I recently installed an FN mfg lower parts kit into my RRA lower. All parts are new. Everything is assembled as per the TM and various other diagrams I could get my hands on. Here's the problem. I manually cock the hammer and squeeze the trigger. The hammer doesn't release crisply at all. It's almost as if there's a delay because I have to squeeze the trigger and hold it before the hammer will fall. I haven't test fired it at the range yet. I was wondering if the problem will fix itself with some use. Any ideas? |
|
It sounds to me that you have a tolerance problem. Do you have access to another hammer/trigger/disconnector? If so swap them out one at a time until the problem disappears. Also see if these parts work in another gun or have the same problems. I would guess swapping parts between two guns would result in two working guns. But I could be wrong. 
|
AR Sponsor