AR Sponsor
Posted: 5/17/2004 8:07:39 PM EDT
|
I purchased a Trijicon Reflex with a mount for carrying handle a while ago to mount on my CAR-15. I put it on and tested on a 25yrd target and I did not hit paper. I lowered the dot as far as it would go and still no paper hits. Hmmmm. One of the guys at the range suggested wedging in some aluminum between the front of the carry handle and the mount. I was finally hitting paper. However, at 200yrds it was 18 inches high. I'm at a loss as to how to fix this problem. Any and all help would be appreciated. |
|
With the Trijicon carry handle mount you should be able to use your iron sights through your Reflex. IF YOUR IRONS ARE ZEROED, sight through them and at the same time reach up and adjust your Reflex so that the aiming point is at the tip of your front sight post. This should get you back on paper. Chris |
|
I have an older Reflex 1 that went in for a rebuild. They're very thorough and turn around is about a month. You have to put the dot on the tip of your front sight post while looking through the irons only. If it's still out of whack after doing that, then send it in. |
AR Sponsor