Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 1/5/2006 2:11:06 PM EDT
I don't have a user/installation manual.

If the stock is already installed, what is the best way to retrofit with a Magpul single point full loop for a single point sling?

I don't want to work against myself by haphazardly removing bolts.

Also, what is the method by which the sliding unit is separated from the tube?

Any and all applicable replies very appreciated.

Standing by.
Link Posted: 1/5/2006 9:31:06 PM EDT
Lets see if I can word this right.

To take the stock off, slide it all the way out. While holding the locking lever in the unlocked position, also hold in the two small side buttons. The stock should then slide off.

To put the single point mount on. Remove the single center screw that faces the receiver, under the extension tube. Then slide the spacer out. Slide in the single point mount and put the screw back in.

Jason
Link Posted: 1/5/2006 9:45:05 PM EDT
[Last Edit: 1/5/2006 9:46:35 PM EDT by Not_so_Clever]
Jason:

Thanks for the reply.

Spacer has a tongue and groove, and is not loose enough when I pull just that bolt from the rear.

Removing the small cross bolt at the bottom does not make it looser. either.

What am I missing? Am I being too prissy with it?

Thanks again.

For clarification: I did not mount this stock.

Link Posted: 1/5/2006 10:01:59 PM EDT
I won’t have access to my rifle until later tomorrow, from memory though, with just the single screw removed the spacer should slide out. It probably won’t slide out very easily.

Jason
Link Posted: 1/5/2006 11:18:50 PM EDT
Jason:

Got it. Done.

Just telling me how to get the outer stock off was very helpful. Thanks.

Top Top